Attaching Wood Shutters To Vinyl Siding

Use a drill with a multi purpose 11 64 inch bit to pre drill holes through the shutter for the screws at each reference mark.

Attaching wood shutters to vinyl siding.

Measure the same distance upward from the bottom of your shutters and make a mark on your siding for the next screw. Screws are used to attach outdoor shutters to wood vinyl and other soft siding. To avoid warping don t attach the shutters tightly. Drill and attach to the mortar not to the brick.

Using metal screws with painted heads is an alternate method to install exterior shutters on all types of siding stucco and masonry. Do not over tighten or this will cause the shutter to dimple. Measure the thickness of the lap on the siding. You ll need a masonry bit and masonry wall anchors or suitable spikes if provided with shutters.

If your shutters do not have holes for screws you should place them near the top of the sidebars. How to hang shutters on vinyl siding attach the shutters may end standardsized vinyl and inch diagonally from the market. Grasp the shutter fastener supporting shank and push it through the shutter hold and into the wall surface. Most vinyl siding is made to imitate wood lap siding so the lap of the siding is measured at the bottom of the simulated wood panel where the real wood would overlap each other.

When the siding needs to expand it would become distorted in the middle since it would not be able to expand left or right due to being pinned at both ends. Approximately 5 inches from the shutter s top is an ideal location for screws. Also drill the hole in the siding 1 4 inch larger than the fastener. Step 3 add these two measurements together then add 1 2 inch.

There are two methods of installing vinyl exterior shutters. To remove shutters do not attempt to pull out the shutter spikes. The first uses non corrosive metal screws. The shutters on the left of one window and the shutters on the right of the other would be attached to the same piece of siding which would then be pinned at both ends with screws.

Tap the shutter fastener gently with a hammer to snug the shutter against the siding.